Just installed two of these (one on each side), and they're solid. I did a lot of research, and considered all the options for MOLLE panels in the bed of my 2018 Colorado ZR2, and I liked these the best. You can get bigger panels that cost a whole lot more, and take up too much room. You can get cheaper panels (not much cheaper) that aren't as solid, and feature rich. These were the perfect combination for me. I was a planning on mounting my Pull Pal with a QuickFist, and hanging one end down to the bed, because I was concerned that these might not hold the weight (~40lbs.?), but once I got them installed, I realized that they will support the full weight, so that's a bonus. Utilizing this little bit of dead space, getting more gear attachment points, and being super sturdy is awesome. They look great; good quality powder coating, and easy to install. I followed the advice of another customer review and modified my oval plastic plugs so that the bolt went through a drilled hole in the center, and cut out some of the plastic in the back so the spanning metal bar has purchase. Then, I also added black silicone adhesive around the seal of the caps to eliminate dust from coming in through all the holes. Because I did this, it took me longer to install, and I had to use a little more elbow grease to get everything lined up, but worth the effort in the end. Would definitely buy again. Thanks Datin!